Salsbury-industries 77000 Series Locker Options Manuel d'utilisateur télécharger pdf

SALSBURY INDUSTRIES

1010 East 62

Street, Los Angeles, CA 90001-1598

Phone: 1-800-562-5377 Int’l Phone: 323-846-6700

Fax: 1-800-562-5399 Int’l Fax: 323-846-6800

www.lockers.com engineering

@lockers.com

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Locker Options – 77000 Series

Installation Instructions

Thank you for selecting Salsbury’s options for standard lockers. We are confident that the quality and construction of the optional items will prove to

be a good investment. These instructions are intended to assist you in assembling various optional items onto the lockers. The items are separate

options and may or may not be included with your order.

Name Plates

The name plates are installed with two (2) #4 slot less screws and

nuts.

Sloping Hoods

The sloping hoods are assembled with ten (10) #10 x 3/8” slot less

screws and nuts. The side plates should be installed over the

flanges of the sloping panel.

The four tapped holes in the bottom of the sloping hood assembly

align with holes preexisting in the top panel of the locker assembly.

Use four (4) slotted or Phillips head #10 screws installed from the

inside of the locker to attach the sloping hood.

Front Bases and End Bases

The front bases are simply snapped into position between the two

legs in the front of the locker unit. No fasteners are required due to

the dimples on the front base flanges.

The end bases are installed and fastened with two (2) screws and

nuts such that the end base front edge is inserted inside the locker

front leg with the end base rear flanges wrapped around the outside

of the locker rear leg.

1 2 3 4 5 6 7

Installation Instructions 1