Salsbury Industries 19055-10GRK Manuel d'instructions télécharger pdf

SALSBURY INDUSTRIES

1010 East 62

Street, Los Angeles, CA 90001-1598

Phone: 1-800-624-5269 Int’l Phone: 323-846-6700

Fax: 1-800-624-5299 Int’l Fax: 323-846-6800

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Cell Phone Lockers - 19000 Series

Surface Mounted Installation Instructions

The surface mounted cell phone locker may be installed on the surface of a wall, on a table or a counter top. It is the installer’s responsibility to

ensure the unit is properly anchored to prevent tearing out of a wall or tipping over on a table or counter top.

Installation of the Surface Mounted Enclosure

Remove the locker unit from the enclosure. Drill mounting holes in

the enclosure to fasten it to the mounting surface. It is important to

use at least four (4) fasteners (not provided) and place one each at

the four (4) corners of the mounting surface (either on the rear panel

or the bottom panel). Choose appropriate hardware for the particular

conditions of the installation.

Installing the Cell Phone Locker into the Enclosure

Install the locker unit into the enclosure by sliding it into the enclosure

until its front peripheral flange is flush against the front of the

enclosure. Open the four corner compartments of the cell phone

locker. Install #8 x 1-1/4 in. long screws (provided) through the top

and bottom of the locker unit into the enclosure. Close the

compartment doors.

1 2 3 4 5 6