Salsbury-industries 4350 Mail Chests Spreader & Pedestal 2-wide Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Meubles Salsbury-industries 4350 Mail Chests Spreader & Pedestal 2-wide. Salsbury Industries 4350 Mail Chests Spreader & Pedestal 2-wide User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-624-5269 Int’l Phone: 323-846-6700
Fax: 1-800-624-5299 Int’l Fax: 323-846-6800
www.mailboxes.com engineering
@mailboxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2011 Salsbury Industries. All rights reserved. (Rev. 01, 11/1/11)
Mail Chests – 4350
Spreader & Pedestal Installation Instructions
U.S.P.S. APPROVED
Thank you for selecting Salsbury’s 4350 mail chest mailbox. This instruction sheet is for installing the 4350 mail chest on spreaders and a pedestal. Other
installation instructions are available for installing the mail chest on a pedestal, or on a deluxe post, installing the mail chest on a newspaper holder, and installing the
pedestal in a concrete footing.
When you install a curbside or roadside mailbox, make sure that it is easily accessible to the mail carrier. By regulation a locked mailbox should be 41” to 45” from
the ground or street surface up to the point of mail entry. The door should be set back 6” to 8” back from the front face of the curb or the road edge. However, you
should check with your local postmaster to ensure that the mailbox is installed according to local regulations. It is important to note that it is not the responsibility of
mail carriers to open mailboxes that are locked, accept keys for this purpose, or lock mailboxes after delivery of the mail.
Installing Mail Chests on a Spreader & Pedestal
4382 2-Wide Spreader
All hardware to attach the spreader to the pedestal is included with the
spreader. To attach the spreader to the pedestal, install four (4) 5/16”-18 X
1” long hex flange head bolts through the four (4) center square holes of the
spreader and through the four (4) tapped holes on the top plate of the
standard mailbox post. Cover the hex flange head bolts with cap plugs.
All hardware to attach the mail chests to the spreader is included with the
spreader. To attach a mail chest, open the front door or rear door of the mail
chest and install four (4) 5/16”-18 x 1-3/4” long carriage bolts through the four
(4) square holes in the inside floor of the mail chest, through the square
spacer, and through the four (4) corresponding square holes in top of the
spreader. Install 5/16” flat washers and 5/16”-18 hex nuts on the ends of the
four (4) bolts protruding below the bottom of the spreader. Repeat these
steps for the other mail chest. Installation is now complete. Additional
hardware provided is not needed and may be discarded.
4383 3-Wide Spreader
All hardware to attach the spreader to the pedestal is included with the
pedestal. To attach the spreader to the pedestal requires simultaneously
attaching the center mail chest to the spreader and to the pedestal. Start by
opening the front door or rear door of the center mail chest and install four
(4) 5/16”-18 X 2” long pan head bolts through the four (4) square holes in the
inside floor of the center mail chest, through the square spacer, through the
four (4) center square holes of the spreader, and through the four (4) tapped
holes on the top plate of the pedestal.
All hardware to attach the remaining two mail chests to the spreader is
included with the spreader. To attach an additional mail chest, open the front
door or rear door of the mail chest and install four (4) 5/16”-18 x 1-3/4” long
carriage bolts through the four (4) square holes in the inside floor of the mail
chest, through the square spacer, and through the four corresponding square
holes in top of the spreader. Install 5/16” flat washers and 5/16”-18 hex nuts
on the ends of the four (4) bolts protruding below the bottom of the spreader.
Repeat these steps for the other mail chest. Installation is now complete.
Vue de la page 0
1 2

Résumé du contenu

Page 1 - Mail Chests – 4350

SALSBURY INDUSTRIES 1010 East 62nd Street, Los Angeles, CA 90001-1598 Phone: 1-800-624-5269 Int’l Phone: 323-846-6700 Fax: 1-800-624-5299

Page 2

SALSBURY INDUSTRIES 1010 East 62nd Street, Los Angeles, CA 90001-1598 Phone: 1-800-624-5269 Int’l Phone: 323-846-6700 Fax: 1-800-624-5299

Commentaires sur ces manuels

Pas de commentaire