Salsbury-industries S-66000 Series See Through Lockers Box Style Manuel d'utilisateur télécharger pdf

See Through Lockers – S-66000 Series

Box Style Installation Instructions

Phone: 1-800-562-5377 Int’l Phone: 323-846-6700

Fax: 1-800-562-5399 Int’l Fax: 323-846-6800

www.lockers.com engineering@lockers.com

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

SALSBURY INDUSTRIES

1010 East 62

Street, Los Angeles, CA 90001-1598

Thank you for selecting Salsbury’s see through box style lockers. These instructions are intended to assist you in assembling the lockers. Assembly of the various locker components

will be with #10 - 24 x 3/8” long slot less screws and #10 nuts (provided). Loosely fasten a screw and a nut into every set of mating holes with the screw heads positioned on the outside

of the locker or on the exposed surface.

One Wide Locker Assembly

Step 1: Attach the top shelf and bottom shelf to the back panel.

Step 2: Turn the back panel on its back with the shelves pointing upward. Attach the

first side panel, the left rear leg, and five compartment dividers to the assembly from

Step 1.

Step 3: Attach the second side panel and the right rear leg to the assembly of Step 2.

The locker chassis is now complete.

Step 4: Attach the pre-assembled door frame onto the assembly of Step 3.

Step 5: Tighten all fasteners checking for squareness of the locker while tightening.

Attach optional sloping hood, end bases or front base (see pages 4 and 5).

Step 6: Place the locker in the installed location and anchor to the floor, wall, or to

both. Individual job conditions will dictate the type of fastening anchors to use (not

provided).

Step 7: Fasten all lockers in a row together by installing fasteners provided through

the side panels. Installation is now complete.

1 2 3 4 5

SALSBURY INDUSTRIES 1