Salsbury-industries 81000 Series Extra Wide Vented Lockers Single Tier Manuel d'utilisateur télécharger pdf

Extra Wide Vented Lockers – 81000 Series

Single Tier Installation Instructions

Phone: 1-800-562-5377 Int’l Phone: 323-846-6700

Fax: 1-800-562-5399 Int’l Fax: 323-846-6800

www.lockers.com engineering@lockers.com

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

SALSBURY INDUSTRIES

1010 East 62

Street, Los Angeles, CA 90001-1598

Thank you for selecting Salsbury’s extra wide vented single tier lockers. These instructions are intended to assist you in assembling the lockers. Assembly of the various locker

components will be with #10 - 24 x 3/8” long slot less screws and #10 nuts (provided). Loosely fasten a screw and a nut into every set of mating holes with the screw heads positioned on

the outside of the locker or on the exposed surface.

One Wide Locker Assembly

Step 1: Attach the top shelf, bottom shelf, and the first single coat hook to the back

panel.

Step 2: Turn the back panel on its back with the shelves pointing upward. Attach the

first side panel, the left rear leg, and the hat shelf to the assembly from Step 1. On 15”

deep lockers attach the double coat hook to the bottom of the hat shelf and attach a

second single coat hook to the first side panel. On 18” deep lockers omit the double

coat hook and substitute a single coat hook with a double bend (not shown) instead of

the second single coat hook (this will accommodate the coat rod).

Step 3: Attach the second side panel and the right rear leg to the assembly of Step 2.

On 15” deep lockers attach a third single coat hook. On 18” deep lockers substitute a

single coat hook with a double bend for the third single coat hook and install the coat

rod as shown on page 3. The locker chassis is now complete.

Step 4: Attach the pre-assembled door frame onto the assembly of Step 3.

Step 5: Tighten all fasteners checking for squareness of the locker while tightening.

Attach optional sloping hood, end bases or front base (see pages 4 and 5).

Step 6: Place the locker in the installed location and anchor to the floor, wall, or to

both. Individual job conditions will dictate the type of fastening anchors to use (not

provided).

Step 7: Fasten all lockers in a row together by installing fasteners provided through

the side panels. Installation is now complete.

1 2 3 4 5

SALSBURY INDUSTRIES 1